Menu

Blog Component

The Guide to Update SKODA KODIAQ Reverse Light

SKODA KODIAQ designs in the Chinese market are housing with solitary reserve light, while KAROQ, Octavia, Superb are designed with double reserve light. Single get light is sufficient for the hatchback vehicle but does not fit the wide vehicle body of SUV layout. It is not brilliant enough as a caution signal and also the rear lights.

 

The rear light of SKODA KODIAQ in Europe market is assembled by Valeo. It contains book light and fog light, which can be brought from the purchasing internet and also can be installed into the vehicle directly yet with a little costly. This sort of rear light can conserve whole lots of time for whom do not intend to make the hand-operated retrofit.

The second approach for substitute is to use led reserve light, however it requires to open the back light real estate and also pierce a hang on the reflector dish to deal with the led light bulb. The rear light is sealed by cool adhesive which requires to bake in the oven in order to open up the assembly. Then put the w16w canbus LED light bulb in the real estate, the power of the w16w LED bulb requirement to reach about 5W to ensure it coincides power as the best side book light.

The installation of the w16w canbus led reverse bulb is as below:

1. Figure out the appropriate position and also pierce a hold to ensure the dimension of the hold can fit the T15 base

2. There will be great deals of scraps in the reflector, so it needs to drink out from the reflector after boring. as well as after that installing the T15 led bulb into the reflector, and also utilize something such as shielded rubber tape to block the hold to make sure that it can seal with warm melt adhesive easily.

3. The base wiring should go across the plastic cover for waterproof.

4. Circuitry needs to link to the best backup light cord directly, it is very simple that. Figure out the best back-up light electrical wiring harness, the favorable pole is dark blue, the planet wire is brown, attach the extension cable to the 2 cables.

Currently the setup is done, switch on the get light, it is brighter than previously.

Search

Archive

Comments

There are currently no blog comments.